Item# 23041800

Product Description

Circuit Board Repair for hard drive data recovery

because this model can't swap the circuit board without transferring firmware to donor board , we focus on fixing the circuit board of hard drive, if we can fix your board , you pay the item plus return shipping cost, if not, return shipping cost only .if your hard drive is mechanical issue, please check our Data Recovery Service

1. Fill the Form and ship your board to us(clients pay the shipping fee to us)
2. We repair the board
3.you pay the item

Typical bad hard drive circuit board symptoms:
  • No power, No Spin, No Sound.
  • Burning smell.
  • The circuit board is extremely hot.(when you touch the board , please be very careful)
  • Power surge. Connected the hard drive case to wrong power supply.
  • There is obvious damage on the PCB board

  • For following situations , most likely the circuit boards are OK ,We do not recommend sending the board to us
  • The hard drive can spin properly .
  • Make clicking sound .
  • Being dropped.
  • Spin well but cannot be detected

  • Please note that this item can fix drives with ONLY circuit board problems. Some drives have internal damages that can't be detected easily. Please do NOT attempt to open the drive without a clean room. There is no return policy for this item.

    Note: Before purchasing, please read:
    1. This is just a PCB (Printed Circuit Boards), not the whole Hard Drive;
    2. It is used as data recovery/repair issues, there is no refund/exchange policy;
    3. It is a buyer responsibility to know if the board is adequate for his hard drive model;
    4. Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your
    drive to be repaired by replacing the PCB;

    Free Worldwide Shipping
    Our Clients enjoy FREE shipping(from us to clients), Item will be shipped by Canada Post Light Packet (air mail).